Bowl Adapter 14 to 16 mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Have a 14mm bong or 14mm rig, but no 14mm piece? Only have a 16mm piece. This is the answer!
- Rating
- 5 / 5
- Likes
- 15
- Downloads
- 107
- Makes
- 0
- Views
- 564
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
An adapter for bongs/rigs. Allows you to use 16mm pieces in 14mm circumstances.
I am using it on my custom bong found here.
Sliced using Cura 5.01
Printed mine in ABS at .3mm layer height @65mm/s with no enclosure on a Kingroon KP3S… So you should have no excuses or trouble printing with PLA at any layer height ≤.3mm. 2 walls. 99% concentric infill. Print however you like, but I did mine like a cone with the big hole on the print bed. Recommend a brim, although I didn't use one. I did inside before outside walls, but I think it might not matter. You should end up with a ~25 minute print time.