Bearing Puller Support for Petamentor/2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a bearing support for the puller motor on the petamentor/petamentor 2
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 113
- Makes
- 1
- Views
- 1,041
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
A 22mmOD, 7mmH, 8mmID bearing used to support the motor pulling the filament on the Petamentor/Petamentor 2
Materials:
22x8x7mm Bearing:https://www.amazon.com/dp/B07XD6PLV1
8MM Diameter Rod (Length:55-60mm, I used 55)
M3 Screw and Nut(To hold Rod)
Notes:
-All Parts are press fit
-8MM shaft can be ground down to be better screwed into
-Line up the bearing and shaft then slide the bottom mount onto the board and mark where the holes are then drill and screw it in.
-Will expand the lifespan of the motor by relieving some stress on the bearings
-I did not cut the 8mm shaft yet