Legs for Ikea DAGOTTO legrest
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€2.76 – €3.37 net (excluding VAT)
For file: DAGOTTO legs_0.2mm_PETG_MK3S_3h15m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.07 excluding VAT (range midpoint).
- Weight reported by the author
- 37 g
- Print time reported by the author
- 3.25 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Better legs for the Ikea legrest.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 20
- Makes
- 0
- Views
- 252
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The rubber tubes used by Ikea slides off, and the whole legrest is a bit low for me. This print fits the pipes of the legrest, and 4 felt pads from Ikea can be glued on.
The pipes of the legrest are a bit wobly, so some glue or scotch/masking tape may be required for a tight fit.
Print it with no support.