Hypercube PSU case with IEC 320 C14 fused switch.

I made this remix because of two reasons. The first is that i converted my P902 into a hypercube, and the added corner brackets made impossible to use the previous case. The second reason is that i wanted to bolt the IEC socket i bought at my local store into the case, the previous version only worked with snap on type of sockets.

Additional changes:

-I elevated the back of the cover, in order the PSU to sit flush onto the case, previously there was a gap of aproximately 5mm.

-I added a reinforcement inside the case, in order to minimize the bending of the front wall when plugin/unpluging the main power cable.

-Moved the side holes for mounting the PSU to the case, as these were not aligned with the holes on my PSU.

IMPORTANT: My psu model is MS-250-12, DEPTH: 51mm, WIDTH:110mm. Check if you PSU has the same dimensions.

-Hardware needed:

screws ; m5x8 -3-pcs, m5x10 -4-pcs, t-nut m4 -4-pcs, m3x8 -1-pcs, washer m3 -1-pcs

zipties (as many as you like)

IEC 320 C14 SOCKET: https://es.aliexpress.com/item/32880955914.html?spm=a219c.search0302.3.53.6ed44e36xfR44t&ws_ab_test=searchweb0_0,searchweb201602_0,searchweb201603_0,ppcSwitch_0&algo_pvid=ebfcb7c0-3848-4571-a438-d4928cd5a98a&algo_expid=ebfcb7c0-3848-4571-a438-d4928cd5a98a-7

Print Settings

Printer:

Hypercube-inspired P902

Rafts:

Supports:

No

Resolution:

Infill:

50

Filament:

PrintaLot PLA

Translucent Green

Category: 3D Printer Parts