Keys Organizer with hidden AirTag
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Keys Organizer with compartment for AirTag or others little things
- Rating
- 4.667 / 5
- Likes
- 268
- Downloads
- 663
- Makes
- 5
- Views
- 8,192
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Key organizer with hidden Apple AirTag
This model was created by remixing the following design.
https://www.thingiverse.com/thing:1008943
When designing, I used the Apple AirTag model made by Gustav
https://www.printables.com/model/255519-hi-res-apple-airtag-model-for-fusion-360-and-more
This Key organizer is Highly customizable. It can hold from 1 to maximum 7-8 keys, dependent of keys total thickness. The maximum key length is up to 71.0mm
Using a program like MeshMixer it is possible to easily increase the number of keys by extending thickness of parts KeysOrganizer_Left_Cover_Off_Center_Pivot and KeysOrganizer_Left_Cover_Off_Center_Pivot.
Because, depending on the manufacturer and country, the keys have different thicknesses, some parts of the organizer will need to be adjusted in Slicer
The attached pdf document (Adjusting_Keys_Organizer_parts.pdf) describes the process of adjusting the organizer parts to the number of keys.
The chamber can hold an AirTag, or others things, like SSD Micro Cards, small Pen Drives, Coins, Pils etc.
Using Extended chamber covers, you can have even bigger chamber
Mandatory parts of the organizer with Apple AirTag to be printed:
KeysOrganizer_Core
KeysOrganizer_Lock
KeysOrganizer_AirTag_Chamber_Cover x 2
KeysOrganizer_Right_Cover_Off_Center_Pivot
KeysOrganizer_Left_Cover_Off_Center_Pivot
For a key stack thickness of less than 8mm, the following additional parts will be required:
KeysOrganizer_Left_Distance
KeysOrganizer_Right_Distance
Additonal replaceable parts:
- For short keys or after drilling an additional hole in the center of the key head
KeysOrganizer_Right_Cover_In_Center_Pivot
KeysOrganizer_Left_Cover_In_Center_Pivot
- For increasing the chamber size to a maximum of 12mm
KeysOrganizer_Chamber_Cover_Minimum
- For increasing the chamber size to a maximum of 24mm
KeysOrganizer_Chamber_Cover_Maximum with KeysOrganizer_Chamber_Cover_Maximum_Distance
Additional requirements:
4 x M2.5mm conical bolt (2.5mm diameter, minimum 15.0mm length)
4 x M2.5mm nut
Print Instructions
Filament: PLA or PETG
Infill: 40%
Supports: At your discretion, flat hanging surfaces will require supports
Layer Height: 0.1mm (first layer 0.2mm)
The tolerances:
Some tolerances are provided for in the design, but it may be necessary to adjust the dimensions when calculating the height of the parts for the calculated thickness of the keys set.
For example, my printer adds 0.1mm to the part height and steals about 0.1mm when using bridge supports
