RoboBuddy
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Here is a print in place robot I designed a while back
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 205
- Makes
- 6
- Views
- 524
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Sculptures
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Here it is the print in place articulated robot.
I printed mine at 0.2mm layer heights without too much issue. You may want to put some glue stick down if you're having trouble with adhesion.
No supports needed in slicer.
You will need to break the integrated supports free by spinning the joints after it is finished.
I would advise against scaling since there are supports integrated into the model and scaling would cause an increased support area. I have included the step file in case you would like to scale in your choice of parametric modeling software, just be sure to also scale down the support areas of the joints as well.
I printed mine in PLA