Printable S-Hook
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a printable S-Hook
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 74
- Makes
- 1
- Views
- 390
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Share Alike
This is a printable S-Hook. It is very similar to "http://www.thingiverse.com/thing:7769" except you define the inside radius of the hook openings.
Instructions
Printing is very simple. Just lay the S Hook flat on the platform and it should build without any problems.
These are the parameters you can adjust:
top_hook_radius:[mm] This is the inner radius of the top S Hook top_hook_radius = 33.5;
bottom_hook_radius:[mm] This is the inner radius of the bottom S Hook bottom_hook_radius = 7.7;
width:[mm] This is the size of the S Hook body (in X&Y directions) width = 10.0;
thickness:[mm] This is the thickness of the S Hook (in Z direction) thickness = 60.0;
start_angle: [DEGREES] This adjusts where the opening in the S Hook starts start_angle = -10;
end_angle:[DEGREES] This adjusts where the opening of the S Hook ends.
Normally end_angle will be ~-90 degrees. This is so the transition from top to bottom hook is smooth. If you want the opening to be somewhere else than adjust this value. end_angle = -89;