MagSafe iPhone Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
MagSafe mount for iPhone with ¼-20 threaded insert. Makes this compatible with any mount that uses ¼-20 thread.
- Rating
- 0 / 5
- Likes
- 41
- Downloads
- 105
- Makes
- 1
- Views
- 1,971
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution
Needed a way to mount an iPhone by its back for an unobstructed view of the Front. Uses a Magsafe iPhone mount to hold the device while providing a ¼-20 threaded insert to mount to just about any tripod, magic arm, or basic photography mount that uses the industry-standard ¼-20 thread. Great for photography or using with any mounting system that used the standard ¼-20 thread.
Needs supports. Tried printing in PLA and PETG. The supports were a bit much with the PETG (pictured), but were easy enough to remove and clean up in PLA. The surface is rough as guts where the supports were, but that will never see the light of day, so it doesn't matter.
The MagSafe mount should friction-fit into the print with just a minimal amount of pressure. The soft pad should extend beyond the print so the phone never touches plastic, meaning no scratches. This worked so well, I don't think I could remove it without destroying the print. I may make a version with a hole allowing you to push the mount out of the print from behind.
Printed in Overture Matte-Black PLA
https://www.amazon.com/OVERTURE-Filament-Printer-Dimensional-Accuracy/dp/B089S2QDHD
MagSafe Mount used
https://www.amazon.com/dp/B097CGPZV3
Threaded insert used
https://www.amazon.com/gp/product/B08PVQX853
Soldering Iron used
https://www.amazon.com/gp/product/B00ANZRT4M
Heat-set tips for soldering iron
https://www.amazon.com/gp/product/B08B17VQLD