Little Lackluster Lack Lifter

What?

These feet are designed to slide onto the lack legs like little booties. One model lifts 10mm and the other lifts 20mm, if you need a different height adjust the z scale in your slicer. eg. need 15 mm? Use the 20mm model and set the Z axis scale to 75%. 

• These lifting booties have cutouts in the corner to allow for less than perfectly calibrated printers. 
• The ID is 54.8mm which should allow it to slip on comfortably and without struggle. 
• Print the test file beforehand for comfort and security.
• The walls are 35mm high on both models.

Why?

My workshop is in an old pickers cabin on the back of a vineyard, and the floors are not level at all. I had to lift one front leg by 9mm and the other by 22mm, but both back legs sat flat on the floor! It was wild, I've installed cabinets in a number of new build houses and so I'm used to seeing a a floor change by 19mm over 6' not 13-22mm over 1'. Like I said, it's an old building.

How?
All hardcore designers use TinkerCAD