MicroUSB Pinboard Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a case for Conrad Bannik's Micro USB DIP 5-Pin Pinboard.
- Rating
- 5 / 5
- Likes
- 23
- Downloads
- 169
- Makes
- 2
- Views
- 782
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a case for Conrad Bannik's Micro USB DIP 5-Pin Pinboard.
Note that the screw holes to mount the board is offset with 1mm because the Conrad's model does not fully match with the pinboards I have.
The model is parameterized, so if you don't like the tolerance or other dimensions you can open the .f3d in Fusion360 and change them.
Print instructions
Rotate the top part upside down, and print both parts without support. The top is designed with a sacrificial layer in the screw hole to eliminate support.
After printing remove the sacrificial layer from the screw hole in the top part.
Use 2pcs M2x4 screws to mount the pinboard to the bottom.
Use 1pc M3x4 screws to screw the to part to the bottom.
Enjoy! :)