Dental Floss Holder with Tensioner V2
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.61 – €0.74 net (excluding VAT)
For file: DentalFlossHolder-PLA_0.15mm_PLA_MK3S_48m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.67 excluding VAT (range midpoint).
- Weight reported by the author
- 6 g
- Print time reported by the author
- 47.4 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Dental floss holder with tensioner, optimized version 2.
- Rating
- 4.714 / 5
- Likes
- 376
- Downloads
- 2,794
- Makes
- 34
- Views
- 10,111
- Reviews
- 28
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial
This design represents a dental floss holder that fixes the main problem of almost all floss holders - tensioning! Floss tends to stretch almost immediately, causing handling problems.
My design uses a movable part that serves the function of both holding the floss in place and providing a way to tighten it. Look at the pictures and you will understand how to use it. I use mine daily and it really works exceptionally well for me. Of course, your mileage may vary.... ;-)
I recommend printing in PETG for higher elasticity, 0.15 mm layer height, 40% infill without supports. PLA also works well, but can be a bit more brittle in the long run.
This is a print-in-place design - after printing just wiggle it a bit to release the moving part.
Note: The design is widely tested for nozzle sizes of 0.4 mm or smaller on different printers. For bigger nozzle sizes (e.g. 0.6 mm) I have added a STL file using bigger tolerances for the tightening sled (0.35 mm instead of 0.2 mm) in the file “DentalFlossHolder_0.35-spacing.stl”. Just load it in the provided PETG or PLA Prusa Slicer files, replace the main object and slice it with the given settings.
Required parts:
- 1 x “DentalFlossHolder.stl"
- Dental floss… ;-)
Here is a tech drawing:

Change history:
- 2023-09-24 - Version 2
- PETG versions of Prusa Slicer file and GCODE
- Rounded fork attachment for greatly improved mechanical load-bearing capacity of the forks (optimization of the force lines)
- Improved version with 40% infill instead of 15% as before
- Increased center hole for easier insertion of the dental floss
- Improved layer adhesion for tightening sled knob
- 2022-08-22 - Version 1
- Initial version