Decoration for original Prusa USB Flash Drive
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.34 – €0.42 net (excluding VAT)
For file: USB Drive Decoration_0.1mm_PLA_MINI_33m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.38 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 33.6 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Made mostly to help intuitively finding the proper orientation while inserting the USB Drive.
- Rating
- 4.667 / 5
- Likes
- 15
- Downloads
- 56
- Makes
- 5
- Views
- 715
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a stunning decoration featuring hex pattern that you can clip on the original USB flash drive that is provided by default with the Prusa Mini. It's not stunning for the design but because it helps intuitively finding the proper orientation while inserting the USB Drive. That was a nightmare to me. I printed my Prusa Mini Base but I did not want to relocate the USB connector and power switch since they are much safer on the side back. Instead of this is decided to design this decoration and now I know the USB drive has to be inserted with the hex pattern visible.
- Update 25-Jun-2023: Added new 3MF and gcodes replacing the grid support with new organic support. The grid supports were very delicate to remove, the post processing will be lot easier with organic support.
Printing
I recommend printing the model from the bottom end on the bed. This orientation will print nicely but still requires minimal support for the key ring hole upper overhang.
Then I recommend printing with .4 nozzle and .1 layer height. Fill density can be set to 0%, there should be no space for filling anyway. The area that requires support have already been highlighted on the 3MF files provided. The original version was using grid support that was quite delicate to remove. A new version was upload to use organic support that will make the post processing lot easier.
Post Processing (grid support)
The model is thin and removing the grid support is delicate. I recommend following the below steps. This does not apply if you used the model with organic support.
- Remove the brim and outside support raft
- Look the model from the bottom end and use a thin blade to cut between the inside support raft and the model. The support raft should not be touching the model but use the blade to make sure it is free.
- Use a small clamp to twist the support columns on the keyring hole on the side. Do both side one by.
- Once both columns are twisted on the side, take both columns between your fingers and twist on the backside. At this step, the entire support should detach in one piece.
- Remove the stringing into the hex pattern if any.
Installation
- Insert your flash drive into your printer and locate the proper orientation. Make sure to install the decoration with the hex pattern visible after removing it.
- Slide the bottom end of the flash drive on the bottom hole of the decoration.
- Clip the décoration on the flash drive body and facilitate the insertion by gently bending the two sides of the decoration.
- Plug the the flash drive back and just forget about the hex pattern all insertions are going to happen smoothly now!