Klein Tools Universal Meter Hanger Clip (CL and MM)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.23 – €0.28 net (excluding VAT)
For file: klein-clip-mag_0.2mm_PLA_MK3S_16m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.25 excluding VAT (range midpoint).
- Weight reported by the author
- 3 g
- Print time reported by the author
- 15.6 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Experimental hanger clip for many Klein Tools meters. See description. Please verify if this worked for your meter!
- Rating
- 5 / 5
- Likes
- 51
- Downloads
- 248
- Makes
- 5
- Views
- 1,216
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
This is a remix of Klein CL220/CL390 Clamp Meter Hanger Clip which should work for all these models that I am aware of: CL800, CL900, CL700, CL600, CL450, CL440, CL390, CL220, CL120, MM600, MM400, MM300. There could be more models. If you are aware of any, please comment and I will update the list. I only have a CL220, so cannot test others, so please comment if you have tried it on the models I have stated.
Just slide the clip on and it should click in place, aligning with the oval bump on the meter. This hanger clip should fit tightly. If you have to remove it, pry the tabs on the sides out slightly, maybe 1mm at most to avoid breaking them, while pulling the clip downward. You should not have problems with it sliding off doing this.
Refer to the link above for more information on using and assembling the magnetic part. You can also skip the magnet and just add a cord or wire to hang it.
I used .2mm layers, 30% fill, and PLA. I have included gcode files for mk3/s/s+ printers.