1 / 4
Swordfish Collapsing Staff
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A collapsing staff inspired by a swordfish
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 73
- Makes
- 0
- Views
- 688
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution
This collapsing staff was inspired by a swordfish,
All collapsing staff are roughly 44 inches or about 112 cm long fully extended but that is highly dependent on tolerances of your printer and the model.
Print Settings
Layer height and infill at your discretion, I use 0.3mm layer height and 7% infill
Make sure your line width in cura is set to 0.5mm and extrusion width is set to 0.5mm in prusa slicer for perimeters
Supports are optional but if used make sure none are in the model above the rings.