Raspberry Pi Stand (A+ B+ form factor)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a raspberry pi stand.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 49
- Makes
- 0
- Views
- 417
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
This is a raspberry pi stand. Its inspired from the adafruit stand for the pi zero (https://learn.adafruit.com/raspberry-pi-zero-stand/) but with a few fundamental changes
The hight where the pi is screwed in is quite high up. Mainly because when you put a hat on the pi zero stand it tended to tip over with the weight. This I hope should be better in this design.
The screw holes are hat compatible so you can put a A+ or a pimoroni black hat hacker on it or just a Hat on its own. Of course you could put a regular pi on this stand but the USB would be sticking out to the side. (Not a big deal for me)
The hole for the cable management is a little higher than the Zero version too because stiff cables tended to make the whole stand lift off the table. This time I hope the placement allows for cable bend.