Dehydrator Filament Dryer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple extension that fits my old Oster FPSTDH0101 Food Dehydrator.
- Rating
- 5 / 5
- Likes
- 34
- Downloads
- 158
- Makes
- 2
- Views
- 2,763
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
No supports. No fasteners. Just four sections that slide together.
Allows me to use my old dehydrator to dry my filaments before or after use and still use it for drying food. This is not a solution for those that want to print from a dryer.
The original .gcode file (called "planar") was going to take 2.5 hours to print. So I sliced the model again using vase mode. This would have taken 1.5 hours to print, but it would not have had the ledge I needed. So I manually created the "hybrid" file which uses the spiral vase mode to print the large thin wall, then switches to the planar mode to print the rest. Prints one section in one hour and 40 minutes (saving almost an hour per print).