Modified Skeleton Waveguide Subwoofer Speaker
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A few simple changes to a fantastic design
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 86
- Makes
- 0
- Views
- 1,290
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I have added a dedicated channel for 16AWG speaker wire and a dedicated enclosure on the rear for RCA jack.
If you have TPU filament, you can print gaskets that will work perfectly. If not, you can still use normal gasket cord material; there is a channel on either side of the sub woofer body that is meant for a 1mm diameter gasket cord material. When the side panels are screwed down, there will be a slight interference fit making an air-tight seal.
The side panels have a 100mm VESA mount pattern on the side.
There is a detailed BOM and assembly instructions with photos here: https://karlquinsland.com/3d-printed-subwoofer-and-arylic-amp-enclosure/