Dual rod holder for samla drybox
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Looking through the samla drybox designs, I don't really like either of them: I don't want to print directly from the…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 15
- Makes
- 0
- Views
- 369
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Looking through the samla drybox designs, I don't really like either of them: I don't want to print directly from the box, so I want the fillaments to be easy to remove.
Also, I prefer not to drill the box, so I designed something that can be glued into the box. I'm not sure how sturdy it turns out to be though.
The rods are 15mm diameter, and 325mm length. However, the length depends on the installation, so I recommend to measure after installing the holders.
It's not on the picture, but I ended up using this to close the lid: https://www.thingiverse.com/thing:393890
How I Designed This
Designed in onshape: https://cad.onshape.com/documents/b46fc101eb60c39d04c71d1b/w/407edcf161062fd8c46543ec/e/debb6b35befa2b4b63e761de
The printed version turned out to be a bit short (i.e. the filaments are too low in the box). It's easy to modify it, but it's good enough for me as is, and I didn't want to upload something I didn't test.
Category: 3D Printer Accessories