Pegboard Hanger For Cables
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.47 – €1.80 net (excluding VAT)
For file: CE3 Pegbrd Cable Hanger x8 Generic PLA lw 0.4mm lh 0.28mm if 20% ext1 210.0C bed 50C.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.64 excluding VAT (range midpoint).
- Weight reported by the author
- 15 g
- Print time reported by the author
- 1.9 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Compact hanger for your co-axial and probe cables
- Rating
- 5 / 5
- Likes
- 29
- Downloads
- 115
- Makes
- 2
- Views
- 558
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Cable storage is always an issue and usually you have too many cables. This hanger brings the most needed cables to you pegboard in a compact format. It has space for 8 ends and you can print more if you need.
Designed for the 1" spacing ¼" holes type of pegboard but if you have a pegboard that's close, you can scale to fit, the holes will change a bit but they don't need exact tolerance
What happens to the free ends is up to you but be sure to fit your hanger high up so that the ends don't tangle on your benchtop. I usually loop them over a pipe to free up some space below the hanger.
Print as in the model, supports is recommended because they print so much better and the cleanup is very easy, a brim will help prevent curling up depending on you build surface.
Print file is for low resolution and takes 1hr 50 min.
I added a version that is flat against the board, 6 positions in case you think that would be better for you setup. Certainly less tangles.
My other pegboard things
1" x ¼" Pegboard hook grommets and mounting spacer