Maytag Dishwasher Impeller
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Dishwasher wash impeller - PETG
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 40
- Makes
- 0
- Views
- 445
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Public Domain
This is a replacement for a Maytag type dishwasher wash/rinse impeller. It is to be printed in 2 parts, top & bottom, and then crazy glued together. Best to print it using PETG because it gets hot inside the dishwasher and I don't think PLA would hold up. If the keyed hole doesn't quite fit your dishwasher shaft then do what I did. I used a small heat gun to slightly soften the PETG at the keyed area and then pushed it onto the shaft of the dishwasher. Then I removed it and now it has the exact size.
I have this in my dishwasher now and so far it has survived a couple of heavy cycles.
(Working since September 16 2022. Still working now September 30 2022.)
(Keyed center is now stripped - October 11 2022. PETG is not strong enough, but the temperature did not affect the part.)
Print Settings: (support only in the center for the shaft hole)
- layer height = 0.4mm
- top layers = 5
- bottom layers = 4
- perimeters = 5
- print speed = 30mm/s, outer perimeter at 70%
- extrusion width = 0.8mm, nozzle = 0.4mm
- bed temp = 90'C
- Hot end temp = 230'C