1 / 7
Tesla CyberTruck Body for OpenRC F1 RC Race Car — image 1
1 / 7

Tesla CyberTruck Body for OpenRC F1 RC Race Car

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Estimated printing price per file

€0.13 – €0.16 net (excluding VAT)

For file: body-headlight_02mm_pla_mk3s_11m.gcode

This is an estimate for one file. You’ll confirm the exact price before ordering.

File and estimate settings

File used for this estimate

Average indicative estimate: €0.14 excluding VAT (range midpoint).

Weight reported by the author
1 g
Print time reported by the author
10.8 min
Source material
PLA
Estimate material
PLA
Estimate printer
Bambu Lab P1S - 0.4 nozzle
Estimate process
0.20mm Standard

Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.

Saved on this device.

A Tesla CyberTruck body that bolts on to the OpenRC F1 car with no mods to the car chassis.

Rating
4.667 / 5
Likes
203
Downloads
632
Makes
6
Views
10,405
Reviews
6

Updated at source:

Model information

License
Creative Commons — Attribution

A Tesla CyberTruck body that bolts on to the OpenRC F1 car with no mods to the car chassis.

Print instructions

After my son printed a 200% version of the CyberTruck model from https://www.thingiverse.com/thing:4063298, it suddenly occurred to us that it was about the right size to fit on the OpenRC F1 car.

I then converted it to fit as a bolt-on body to the OpenRC car with no mods to the car chassis. It turned out that scaling to 209% matched the wheelbase perfectly. It uses the same M3 hardware and techniques to assemble as the OpenRC F1 car.

The initial version got T-boned pretty bad in our first race with it, so I redesigned a few things to beef it up a little bit.

I printed it at .3mm resolution with 2 perimeters and 8% infill. Some of the parts have an alternate version with built-in support. I also have matching modifier meshes so you can reduce filament usage on the built-in support. I use 1 bottom layer, 1 perimeter, 3 top layers, and no infill for the built-in support.

I printed the middle body section horizontally because the piece is stronger with the layers in that orientation. However, it can also be printed vertically if you want the layer lines to match the front and rear body pieces.

Just for fun I added a "broken" window option. I also added a taillight and headlight for a bit more detail, they can be printed separately out of transparent and red filament and glued on. There is an alternate version of the tailgate with the taillight built in, where you can pause the print and switch to red filament on the last couple of layers.

V2 Update

I made some minor changes on a few files. Both the front and rear frames have a thicker inner cross member for more strength. The rear cross member has also been raised a little bit for better clearance over the motor. I also widened the holes on top of the wheel wells so hopefully they will print a little better.

I thickened the front tab of the hatch for a tighter fit.

Tags