Titan Aero Mounts for Mutant V2

After building a mount for my new E3D Revo Hemera and Wham Bam Systems MUTANT V2 quick change system, I needed new plates for my older print heads.

Specifically a Titan Aero 2.85mm and a Titan Aero Reverse 1.75mm hot ends.

I started with the original ITWorks hot end mounts from Thingiverse (https://www.thingiverse.com/itworks/designs) and took away everything that didn't work for me. Building a new baseplate and attaching their mounting sculpt onto it.
It took a few iterations to get the hot end aligned where I wanted it on the bed, but here is the final result.

I also took their fan design and shaved about 15mm off of it, and removed the front for better visibility.  I recommend getting some copper or brass washers so that you can align the heater block front to back instead of sideways. Even with the silicone boot, the fan can start to deform after a while. Front to back offers better separation from the fan shroud.

I printed all of these in the long orientation, with the base plate aligned with the Z-axis. Used PETG, 4 perimeters, and 20% infill. As printer parts, I tend to err on the side of stoutness.
You can probably use less, if you are trying to shave grams off of you hot end weight.

I made these for the Lulzbot TAZ 4, but since they are for the Mutant V2 mounting, you should be able to use these with any printer you can mount the Mutant V2 base plate onto.

For the TAZ 4 you will need the X-Axis carriage and spacer in my other design here → https://www.printables.com/model/267530-hummbug-remix-for-taz-45-mounting