Vase Mode Pen/Pencil Holder for Peg Board
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.36 – €0.44 net (excluding VAT)
For file: CE3_185-7 TOP (1).gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.40 excluding VAT (range midpoint).
- Weight reported by the author
- 3 g
- Print time reported by the author
- 30 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This Pen/Pencil holder is printed in vase mode with separations.
- Rating
- 5 / 5
- Likes
- 202
- Downloads
- 378
- Makes
- 4
- Views
- 2,903
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
By using VASE MODE (single layer print, except the 3 layer floor), we save material/print time and still have a functional holder for Sharpies, pens, and pencils.
The separators are simply depressions in the wall that go 75% of the way from back to front. These separators are reasonably stiff.
The box is secured to the peg board with retainers at the top and bottom. The pegs that go into the peg board are press fit. I had trouble making pegs with a slot in the center that expanded when pushed through the peg board. These pegs tended to fail. So I used a press-fit peg design.
The top retainers are slotted, which prevents the holder from sliding left/right as well as preventing it from falling off the peg board.