4040 Mount for StreamDeck XL
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Designed to connect to a Monstertech Mouse Plate for a Chair. But should connect to the end of any 4040.
- Rating
- 0 / 5
- Likes
- 41
- Downloads
- 328
- Makes
- 0
- Views
- 3,361
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Built for my own Simpit, but others might find it useful. Images are in the orientation I printed out each object. Hinge Arms Long or Short can be printed, I use the long version. A total of 3 is required to attach to the Deck Hinge.
Only the 4040Connection piece requires support, just the curved section touching the base. The Angled slope is printable without support just make sure the angle is set to 47 or greater. Also the fit is tight enough it doesn't need to be bolted into place.
Printed with Cura using ZipZag fill of 15%. M4 blots would be best, but I went with M5 that slightly cut into the plastic to hold the joints in place.
This a more a kitbase of Mount Anything and StreamDeck XL object. Couldn't find the original project on this site.