1 / 2
Skådis - TicTacToe
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A little TicTacToe to get distracted by when life get too busy.
- Rating
- 0 / 5
- Likes
- 37
- Downloads
- 45
- Makes
- 1
- Views
- 360
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Board Games
- License
- Creative Commons — Attribution — Share Alike
Disclaimer:
This model use @Xuis delightful Skådis T-Clip System, go check his page!
What is this?
This is a little TicTacToe to get distracted by instead of finishing this project you started 3 months ago.
Assembly instruction
Everything is press to fit, with a tight tolerance (0.mm for the part holding the T-Clip to the board, 0.12 for the faceplate to the board).
I will upload more version later for various printer tolerance.
You need to print:
- 1 T-Clip
- 1 board.
- 1 faceplate.
- A couple of TicTactToe pieces, you can start with 4 of each and make more as needed.
- Insert the T-Clip in the board until it is snug with the board face.
- Attach the board to the Skådis by inserting the T-Clip and twisting it.
- Attach the faceplate to the board, the faceplate inner edge will go over the board outer edge
You are ready to play! When you want to start again put your hand under the board and remove the faceplate, all the pieces will fall in your hand!