Geeetech A10 (01.2019 Edition) Board_Cover_60mm_Fan
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ich habe mir einen Abdeckung für das Board meines Geeetech A10 entwickelt weil ich bei sehr lang dauernden Drucken ab…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 13
- Makes
- 0
- Views
- 135
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
Ich habe mir einen Abdeckung für das Board meines Geeetech A10 entwickelt weil ich bei sehr lang dauernden Drucken ab und zu das Problem hatte dass die Steppertreiber zu heiß wurden und ich Schritte verlor, aus diesem Grund hab ich mir einen 60 x 60 mm Lüfter mit 10 mm Dicke bestellt, den hab ich leider unter der original Abdeckung nicht untergebracht.
Mit den originalen Steppertreibern passt die V2
Nach Tausch der Steppertreiber auf TMC2208 musste ich den Lüfter etwas weiter nach oben setzten, da er an den neuen, höheren Kühlkörpern streifte. in diesem Fall bitte die V3 verwenden.
English (by Google translate)
I developed a cover for the board of my Geeetech A10 because I had the problem with very long lasting prints that the stepper drivers got too hot and I lost steps, so I got a 60 x 60 mm fan with 10 mm thickness ordered, unfortunately I have not accommodated under the original cover.
With the original stepper drivers fits the V2
After replacing the stepper driver on TMC2208 I had to put the fan a bit further upwards, as he grazed the new, higher heatsinks. in this case please use the V3.
Print Settings
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0,2
Infill:
15 %
Filament: SUNLU PETG Orange, Transparent
Category: 3D Printer Parts
