1 / 19
Upcycling: Alte Schrittmotore als Lagerbock nutzen — image 1
1 / 19

Upcycling: Alte Schrittmotore als Lagerbock nutzen

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Schrittmotore sind stabil und haben in der Regel hochwertige Lager verbaut. Warum also nicht alte ungenutzte oder…

Rating
0 / 5
Likes
3
Downloads
13
Makes
0
Views
271
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Schrittmotore sind stabil und haben in der Regel hochwertige Lager verbaut.

Warum also nicht alte ungenutzte oder defekte Motore wiederverwenden statt zu Entsorgen.

Darum hier ein paar Teile, um die Spulen oder Magnetrotore in den Motoren zu ersetzen,

um diese als Gegen- oder Umlenklager zu nutzen.

Wenn man die originale Welle dann noch durch eine 5mm Stange ersetzt, ergeben sich vielfältige Möglichkeiten.

Auf jeden Fall muss entweder die Spule oder der Magnetrotor ersetz werden, sonst wirkt der Motor als Bremse, was ja auch durchaus mal erwünscht sein kann.

--------------------------------------------------------------------------------------------------

Stepper motors are stable and usually have high-quality bearings installed.

So why not reuse old unused or defective motors instead of disposing of them.

So here are some parts to replace the coils or magnet rotors in the motors,

to use them as a counter or deflection bearing.

If you then replace the original shaft with a 5mm rod, there are many possibilities.

In any case, either the coil or the magnetic rotor must be replaced, otherwise the motor acts as a brake, which can sometimes be desirable.

Category: 3D Printer Parts

Tags