Custom desk mounted Game controller
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a custom game controller i designed from parts i had laying around, its based on a Teensy 3.2 board.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 26
- Makes
- 0
- Views
- 674
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Hi i created this Custom Game controller, i use mainly for simulator games like Kerbal Space Program or Farming Simulator, from some parts i had laying around.
Its based on a Teensy 3.2 and the programming and wiring was done by following this guide: (Guide).
Buttons are these 16mm arcade buttons (link)
and the Joysticks is this one (link)
I used a Lasercutter to cut the plates from 6mm plywood, but i also included the .3mf files if you want to use a printer or customize the layout.
For mountiung to the table i used M8 t bolts and washer nuts that are used for 40mm aluminum t-slot:
I installed the buttons and the joystick with the provided mounting hardware and then i glued the parts together using epoxy in these positions on each side:
then i marked the top corner piece screw hole and drilled a 4mm hole, after that i secured the top plate to the table holder with two M4x20mm screws.
one Teensy 3.2 has enough inputs to run two of these controllers, i plan on making a “patch” cable to connect one to the other.
Needed Parts:
(1x) Joystick (link)
(5x) Buttons (link)
(2x) M4x20mm bolts
(2x) M8 t-bolt (10mm) min. 15mm long
(2x) M8 washernuts
2 part epoxy