1 / 5
Philips Avent Connected Baby Monitor mount — image 1
1 / 5

Philips Avent Connected Baby Monitor mount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remix of a mount for Philips baby monitor, so it can connect to a round bar, e.g. on a Snuzpod.

Rating
0 / 5
Likes
10
Downloads
101
Makes
0
Views
1,322
Reviews
0

Updated at source:

Model information

Category
Bedroom
License
Creative Commons — Attribution — Noncommercial — Share Alike

Adjusted to fit a round bar of 24 mm diameter (e.g. for a Snuzpod). Use an M3x25/30 screw + nut to tightly secure the crib attachment. I added some rubber to the platform to prevent the camera from wobbling. Also adjusted the feet for a better fit, and added a compatible M6 hex knob.

You can print all parts without supports. You might want to print the feet with a slower print speed, as they are quite small. 

For all parts, except the feet, I used:

  • Extrudr PLA
  • 0.3 mm layer height
  • 0.4 mm line width
  • 60 mm/s print speed
  • 100% infill on all parts, cause I don't want them to break ;)

For the feet, same as above, except:

  • 0.2 mm layer height
  • 0.32 line width
  • 20 mm/s print speed

Check the source for additional information on the model.

Tags