Brake Line Guide KTM, Husqvarna, GasGas
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a brake line guide for rallye bikes and adventure bike convertions.
- Rating
- 0 / 5
- Likes
- 43
- Downloads
- 454
- Makes
- 1
- Views
- 2,398
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I use the brake line guide on my 2018 KTM EXC F450 which is equipped with a navigation tower for rallye racing. It will fit on all bikes with a similar fork.
The updated version is short and got an offset in order to get more clearance between the guide and the navigation tower.
For installation I use Rovaflex 11x260 flexible zipties. You can use regular zipties as well. Just snap the guide over the brake line. Use a regular 20mm plastic screw as shown.
The guide is printed in Extrudr Flex Hard with a shore D58. NinjaTek Armadillo or another TPU with a shore higher than A95 should be fine.
I used for printing:
layer height 0.2
line width 0.42
wall line count 4
top and bottom layers 8
infill 20% Grid
no support
Printer: CR10 V2… yes, the bowden extruder prints even soft TPU (Shore A60) like a champ.