2 liter PET Bottle Bottom Stabilizer for Willy's Eldorado Kolsyrad vatten
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
To stabilize 2 liter PET bottles so they don't fall over when their bottom breaks/gets dented.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 17
- Makes
- 0
- Views
- 234
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Public Domain
This is for 2 liter PET bottles with a diameter of 100mm. Tested on and designed for Willy's Eldorado Kolsyrat vatten bottles here in Sweden, but may work for other bottles. Our bottles have a small lip at about 48mm up from the bottom and the model has little “claws” to grab over that lip. Additionally you can print a lock/tightening ring to slip over the main part if you want more tension to hold the stabilizer in place.
What is this for?
We reuse our 2 liter bottles a lot as drinking bottles but they always get their bottom dented eventually and then they tend to fall over since they're not sitting straight anymore. Unsurprisingly this is a very niche problem and I could not find an existing solution to this so I made this.
Print settings
I printed this in PLA without supports on an Ender 3 v2 and it worked fine except for some stringing between the towers. It may work better in PETG due to it being less brittle but I don't have any of that here to test that.