iRobot Roomba charger dock anchor
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple holder for the iRobot Roomba chager base, intended to be glued to the floor using double-sided tape.
- Rating
- 0 / 5
- Likes
- 23
- Downloads
- 162
- Makes
- 0
- Views
- 1,595
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
A simple holder for the iRobot Roomba chager base, intended to be glued to the floor using double-sided tape. It holds the charger in place, but it can still be easily removed (which would not be the case if you just glued in place the charger itself). We use it to park our Roomba under our couch where there's otherwise nothing to rest the charger against.
Use a rubber cord with simple knots for the fastening strap.
The holes in the sloped section can be used to secure the charger cable.
I'm not uploading the fusion file at the moment as it is embarrassingly messy, if you need it, just write me..
Print instructions
Prints very easily, nothing special, two perimeters with 15 infill are just fine.