Makerbot Replicator 2 Logitech Webcam pro 9000 mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A rather tall stand for the logitech webcam pro 9000. prints on it's side with no supports. The Replicator 2 did a…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 13
- Makes
- 0
- Views
- 234
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
A rather tall stand for the logitech webcam pro 9000.
prints on it's side with no supports. The Replicator 2 did a great job bridging. (first time I tried...)
I added another stand, this one with a flat bottom that can be glued on top of a raspberry pi case... :)
Instructions
Prints on it's side, no supports, The makerbot did a great job of bridging the overhand. The only issue was I did not use those little disks in the corners, nor did a use a raft, so it warped upward slightly... so i have to cut the top side so the webcam would fit in the slot... worked out well though, holds it snug, and makes putting the cam in and removing it easy... I also used some felt with an adhesive back to make the stand a bit more snug on the top of the replicator 2. Works well, keeps the camera far enough away to see the full build plate when it's in it's top position. :)
Hope you like it. :)
Going to hook it up to a raspberry Pi so I can monitor prints remotely :)
Category: 3D Printer Accessories