1 / 14
Pump Jet (32mm 2212/2216/2217/2440 Motor) — image 1
1 / 14

Pump Jet (32mm 2212/2216/2217/2440 Motor)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

An offshoot of my project https://www.thingiverse.com/thing:4606971 RC Pump Jet boat, I modeled a stand alone water…

Rating
0 / 5
Likes
54
Downloads
423
Makes
0
Views
4,698
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

An offshoot of my project https://www.thingiverse.com/thing:4606971 RC Pump Jet boat, I modeled a stand alone water jet originally intending boat to be modular in design. After consideration I decided to just integrate the pump jet with the boat body rather than try to seal the modular parts against water ingress.

 

Needz MOAR pump?  4/3 scaled pump and parts here https://www.printables.com/model/413647-rc-boat-pump-jet-boat-large-yao-kong-chuan-pen-she saved as inlet duct flanged

This model might still be useful for someone though. I've also kept the motor separate from the pump jet in case you want to model your own motor housing for different motors.

With the 3/19/2021 updates to stator and nozzle it reliably runs at all thrust levels once primed - smoothing and water proofing the inner running surfaces of the pump inlet via wax, epoxy or other means is recommended for reliable operation.

There is a split line at the motor mount, this is there in case you want to follow the same design philosophy as my boat project where the motor mount joins the two halves of your printed boat. Also note that for the part Inlet Duct you will need to specify supports touching build-plate as there is an unavoidable overhang for the mounting flange otherwise print settings will be the same as specified for the boat project mentioned above. Depending on your weight limitations you might want to specify more walls than my boat project to make the parts sturdier - I was constrained by the displacement of my hull.

Note caution is warranted with the cooling impellers - the layer adhesion issues inherit to 3d prints makes it possible for the impellers to fracture under load. Wear eye protection and be mindful of risk when using. For added safety consider printing cooling impellers in TPU - higher layer adhesion should make failure less likely. Slicer setting recommendations can be found in my boat project

BOM:

For build instructions please go to post processing pictures at project https://www.printables.com/model/291645-rc-boat-pump-jet-boat-yao-kong-chuan-pen-she-beng

Category: R/C Vehicles

Tags