1 / 6
Car Presence Detector Housing
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a housing I designed for a Car Presence Detector I use in conjunction with Home Assistant and ESP32
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 39
- Makes
- 0
- Views
- 361
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Wiring is pretty straight forward. Cut your wire at no more then 1" in length, and keep them as flat to the boards as possible.
GND - GND
5V - VCC
D1 - Trig
D2 - Echo
(Note: The links below state adding resistors to the 5V line. I found this wasn't necessary, So long as your using the 5V Ultra Sonic Sensor.
You will also require a single M3 3x8mm screw to fasten cover.
Ultra Sonic Sensor
D1 Mini