Bike - Brake Cable to Shift Cable Clip - Flat Front

A clip to hold 5mm brake housing and 4mm shift housing together on your bike to keep things nice and tidy and rattle-free.

Flat front design solves the problem where cables may pull away from each other (see this design). Also, its a great place to put a logo!

Print Settings:

• Material: PETG recommended
• Perimeters: ≥3, should be solid perimeters
• Supports: not required
• Orientation: print vertically, see uploaded gcode
• Brim: Optional if you have bed adhesion issues.  Use cable_clip_v3_easybrim.stl and “Outer Brim Only” option for easy post processing.

Updates

9/2/23 - added an easy brim model

I added model of v3 that should give a little bit better bed adhesion by making a full loop on the first print layer.  Additionally, adding a brim is much easier to post process now using “Outer brim only” option. cable_clip_v3_easybrim.stl 

8/21/23 - added v3

I needed to remove the v2 clips…and they were on there a little too well.  I ended up breaking the clips to get them off.

• redesigned to have single entrance that makes it easier to attach/remove without compromising the designs ability to prevent cables pulling apart from one another.
  • recommending PETG only for the flexibility/toughness required.
• fixed stl orientation for v2 stl
• added a print file

11/30/22 - added v2

• Increased internal diameter for 4mm cable
  • original model could be too tight on 4mm cables and could cause creep over time
• Increased wrap around cables
  • covering more of the cable makes it harder for cables to pull out
• Decreased the length to 14mm
• Added .f3d for people to adjust for their own needs