Hills Hoist Handle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
This handle is for a pre-1950 hills hoist that has a narrowing in the crank handle 25-29mm from the proximal end. The crank shaft for this handle is 14.5 mm diameter. I have narrowed the internal part of the handles to sit in the divot at approximately 27cm to sit in the 11mm diameter section of the shaft.
the -16 uses a small screw to keep the handle from wandering off
I will add a grub screw set-up in the near future
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
No
Resolution:
.4
Infill:
15 (can do 10) cubic
Filament: Prusament PETG black
Notes:
This handle is for a pre-1950 hills hoist that has a narrowing in the crank handle 25-29mm from the proximal end. The crank shaft for this handle is 14.5 mm diameter. I have narrowed the internal part of the handles to sit in the divot at approximately 27cm to sit in the 11mm diameter section of the shaft. I used tinker cad.
Category: 3D Printing