1 / 8
Ender-3 V2 Front Electronics Housing | Remix
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ender-3 V2 Front Electronics Housing + Raspberry Pi case
- Rating
- 5 / 5
- Likes
- 75
- Downloads
- 242
- Makes
- 3
- Views
- 2,111
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
New updated model here!
----
This is a remix from user @Pedrolamas
What I noticed right away was that the back screws used to secure the top are in an akward position.
They either didn't line up, or were barely reachable. I ended up just using the front screws and leaving the back screws out.
What I changed:
- Changed the back screw design to a slide system. There are no more screws in the back.
- Added another fan cutout to the right side for the Raspberry Pi.
- Turned the position for the Raspberry Pi 90 degrees.
- Made a cutout on the left and right top guides, to accommodate for the fan so the top can sit flush.
- Made a cutout for the Z-axsis and Z end switch wires to go to the motherboard.
- Reinforced the back for more rigidity.
- Reinforced the front for more rigidity.
- Moved the fan position to accommodate for the micro usb port on the motherboard.
Printing:
Make sure that the top pieces are turned around 180 degrees.
- Resolution: 0.2
- Infill: 20%
- Generate Support: checked
- Support Structure: Tree
- Support Overhang Angle: 50.0
Print time aprox. 28.5 hours