Grumpy Pumpkins Recessed for LED Lights
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A very simple remix of @scampbell's fabulous grumpy pumpkin ("grumpkin"). I pulled the original flat-bottomed model…
- Rating
- 4 / 5
- Likes
- 8
- Downloads
- 39
- Makes
- 3
- Views
- 240
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Autumn & Halloween
- License
- Creative Commons — Attribution — Share Alike
A very simple remix of @scampbell's fabulous grumpy pumpkin ("grumpkin"). I pulled the original flat-bottomed model into Meshmixer to hollow out the center for two different sizes of LED light. The smaller uses a
which is small, cheap, and just bright enough. The larger uses a
which produces a ton of light in adjustable colors, making for some cool effects with both the face and the infill.(LINKS NOTE: I am not an Amazon affiliate, and receive no remuneration if you buy through those links. I am, however, a Parkinson's patient, and I'd be most grateful if you'd be willing to direct an Amazon Smile purchase to the Michael J. Fox Foundation, to support Parkinson's disease research.)
The smaller grumpkin uses a domed cavity, while the larger uses a conical top to allow better light penetration toward the top. For the finished product, I had by daughter airbrush the stems a deep green.
Printed on a Creality CR-6 SE, using
Topzeal Translucent-Orange PLA
No supports required.
Print Settings
Printer Brand:
Creality
Printer:
CR-6 SE
Rafts:
Yes
Supports:
No
Resolution:
0.2
Infill:
20%
Filament:
Topzeal PLA Translucent-Orange
Post-Printing
There's no required post processing, but you can optionally tape off the stem (@scampbell's model has a lovely little ridge that makes this easy) and paint it green.