aeromine testing part-double wing

Hi There,

Ilooked at this information yesterday ybout aeromine but I thought it is maybe a hoax again...so I realise a double wing 3d part to be printed which I build to suck water from below. when wind/ an air dryer was used to blow on it....howexer I did not observe any water climbing up the drinking strawbut sadly it did not work... I would welcome if aeromine a 3d printed test version open to us.

the concept is not very new: you try to focus air in order to get succion effect. using a double wing. where inbetween the air will be accelerated and at the end I put a tube like structure: hoping to get some coanda effect or like the air multiplication principle used by bladeless blowing device : move more air to create greater succion...

I used first a grid llike intead of a fence to reproduce the idea of pressure repartition. that they show... to ad micro- vertices of turbulent air... as one of their demo video claimed...

I am not fully satisfied of this design...but one can build on this one.easily. and show for himself...

here: this is only as test object . no commercial.

please turn yourselves to Aeromine technologies for any commercial application.

For me it did not worked as intended (sadly!!) maybe the design needs more optimisation!!!

I am not paid by Aeromine/ I was curious of the tech behind!

like the story around the powerpod

Here I put a second version of the double wings the convex part is between the two wings and not the flat part....It fails working as well...

Regards.

Frog Frog

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

0.2 mm

Infill:

Filament: purefil pla brown

Notes:

Category: DIY