FTC Motor Wire Clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Available in stl (inches or millimeters). A two-part 3D print that allows can be mounted to Actobotics® standard…
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 47
- Makes
- 0
- Views
- 457
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Available in stl (inches or millimeters).
A two-part 3D print that allows can be mounted to Actobotics® standard channel. The 6 wires slots are for (4x) 22AWG Encoder Wires and (2x) 16AWG Power Wires.
All holes use 6-32 bolts. Those that mount the piece to the frame require a nut. The top piece that is fastened to the bottom does not require a nut. This is because the hole is smaller diameter at the bottom piece, allowing for you to thread it with a tap, or just use the bolt, and force it through the plastic.
NOTE: May cause damage to wires if you overtighten the top piece.
Print Settings
Resolution:
1/128" or 200μm
Infill:
100%
Filament: Any ABS
Category: Electronics