Vase mode Jack-o'-lantern - Halloween pumpkin lamp
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.55 – €0.67 net (excluding VAT)
For file: CLASSIC FACE_0.15mm_PLA_MINI_44m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.61 excluding VAT (range midpoint).
- Weight reported by the author
- 5 g
- Print time reported by the author
- 44.4 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A set of pumpkins with expressive faces that you can print (mostly) in vase mode to save time and filament.
- Rating
- 4.883 / 5
- Likes
- 1,585
- Downloads
- 9,175
- Makes
- 185
- Views
- 33,060
- Reviews
- 162
Updated at source:
Model information
- Source
- Printables
- Category
- Autumn & Halloween
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
If you're running late with your Halloween decoration or just don't want to use up half a spool of filament for a decent sized pumpkin then these models were made for you!
I've designed these Jack-o'-lanterns as a late entry for the Printables Halloween Flash Contest.
They are perfect to store Halloween candy and interestingly because of their thin walled nature they work as “inverse” lanterns. To avoid a the unintentional extra spookiness use an electric candle. :)
The main part of each pumpkin is optimized for vase mode. Print them with a 0.8 mm nozzle or -as I did- with a 0.4 mm nozzle using 0.8 mm line width. Keep the layer height relatively low to avoid the separation of perimeters around the mouth and eye areas. With my presliced gcodes and prepared project files each pumpkin can be printed in roughly two hours.
The rest of the lanterns can be printed normally (the stem needs no infill) and should be glued in place.
