1 / 4
Card Holder (Uberstax imitation)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Card Holder for Boardgames, modeled after UberStax suitable for 3D printing.
- Rating
- 5 / 5
- Likes
- 64
- Downloads
- 586
- Makes
- 4
- Views
- 2,852
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Board Games
- License
- Creative Commons — Attribution — Noncommercial
I modeled this similarly to UberStax, although measurements might differ. I haven't tried if it will fit with the UberStax sold. There are multiple ways to connect the pieces together as seen below.
All pegs have a 0.2mm clearance with their corresponding hole.
Printing
Print lying down (All 4 pegs should need supports)
Use 0.2mm layer height.
Add support for the pegs (ONLY THE PEGS)
Bridging should take care of the holes.
Depending on your printer, you might need to sand the pegs slightly.