Elegoo Neptune 3 Direct Drive - Sherpa Mini Extruder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A quick-to-print solution for mounting an Annex Sherpa Mini extruder to the otherwise stock Neptune 3.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 70
- Makes
- 0
- Views
- 1,673
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Why?
I bought the Neptune 3 to print RC Planes and was frustrated by some of the extrusion issues I was seeing. The Sherpa Mini is a lightweight and reliable extruder, so it was a no-brainer to add it.
While this does add some weight (~150g-ish) to the x-carriage, it shouldn't be a problem at normal speeds for PLA/TPU. The x-axis is significantly lighter overall, since the stock extruder and stepper weigh 380g+.
Warnings:
You will need to be able to cut/solder the new stepper connection to the existing wiring or use a JST-PH connector kit and a soldering iron to terminate the new stepper connection with a plug that will plug into the existing wiring harness.
You will also need a soldering iron or some other method to install the M3 heatset inserts.
Parts Needed:
1x - Annex Engineering Sherpa Mini Extruder
1x - PTFE tubing (comes with Sherpa Mini kits)
2x - Brass M3x5x4 Heat Set Inserts
4x - M3x12mm screws (two for extruder and two for mount)
Optional Parts:
JST-PH Connector Kit (for stepper connection)
ZipTies
Printing:
Files have been oriented for printing and don't need supports.
Scale the parts up to 101.5% if you are using ABS. No changes should be needed for PLA or PETG. I used ABS but PLA should be fine.
Install:
- Power down printer
- Remove existing extruder
- Remove PC4-M10 fitting on the top of the hotend
- Remove fan shroud screws
- Install M3 heatset inserts into the mount. They will be where the SherpaMini will attach.
- Push mount down onto red aluminum part where the PC4-M10 fitting was. It should be a snug fit and sit flush with the top of the carriage.
- Route existing wires out from underneath mount.
- Screw mount/fan shroud back onto carriage with longer M3x12mm screws.
- Determine correct length of PTFE tube to put between the Sherpa Mini and the hotend. Install spacer over this length of PTFE to keep it aligned.
- Install Sherpa Mini with 2 M3x12mm screws.
- (optional) Route stepper wires back through existing wire loom.
- (optional) Use JST-PH kit to make connection from stepper wiring to existing cable.
- Screw the PC4-M10 fitting into the printed guide and reinstall it where the extruder used to be using old screws from the original extruder. Reconnect what is now a ‘reverse bowden’ tube to it.
- Trim reverse bowden tube to appropriate length and install into top of Sherpa Mini.
Configuration:
Direction:
Make sure your extruder is turning the correct way. If it is turning backwards, you'll need to either swap wires or make the change in Marlin.
E-Step Calibration:
Determine the new esteps needed for accurate extrusion. A good place to start is 887.