BLV MGN Cube double mosquito

This is a remix of the original BLV Cube: https://www.thingiverse.com/thing:3382718
Since Thingiverse no longer works, I post my remix here.

List of major changes:

• Double mosquito bowden hotend setup
• The limit switch mount on the left is increased so 10T85 switch can fit into it
• Removed 40mm fan
• Add LJ12A3-4-Z sensor mount
• Replaced M3 nuts with brass M3x4mm threads
• Shorten the fan duct

Print instructions

Marlin Configuration.h:

define HOTEND_OFFSET_X { 0.0, 18.8 }

define NOZZLE_TO_PROBE_OFFSET { 9.4, 23.5, 0 }

BOM:

• Screws form original BLV project
• 2x mosquito hotend clones: http://ali.pub/4pqors
• 1x 10T85 or similar limit switch
• A few M3 x 4mm brass threads: http://ali.pub/4pt3xx
• 5015 radial fan
• LJ12A3-4-Z sensor probing

How to assemble:
Insert the brass thread into the 4mm holes of the plastic parts (Xcarriage-_double_mosquito_locker, Xcarriage-_Front_plate_For_double_mosquito, Xcarriage-_Rear_plate) using a heated soldering iron (as in the video: https://youtu.be/-ZlDRSxjoqY?t=243).
Then you can assemble the design as in the original BLV Cube model.
Watch the video on the assembly of the printer, there is a moment with the assembly of the hotend. Just please insert the screws from the back of the Xcarriage-_Rear_plate, and not vice versa (error in the video).
Thanks to this, the hotend will be very easy to dissemble, because its main part can be detached indiscriminately from the carriage.

Full model: https://a360.co/3cnV2HA