1 / 3
Mount for RAMPS 1.4 w/ Arduino Mega 2650 and MOSFET board. — image 1
1 / 3

Mount for RAMPS 1.4 w/ Arduino Mega 2650 and MOSFET board.

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A simple bracket to hold a RAMPS setup and a MOSFET board to a limited surface like the side of an Anet A8.

Rating
0 / 5
Likes
3
Downloads
66
Makes
0
Views
816
Reviews
0

Updated at source:

Model information

License
Creative Commons — Public Domain

I designed this because I don't trust the tiny MOSFETs on the RAMPs board any more than I trust the ones on the factory Anet board, but the MOSFET was hard to mount in any reliable or attractive way. This has a standoff of around 12mm to allow for routing wires under the board.

There are 3 through holes with a diameter of 4mm for the screws that pass all the way through and affix the entire assembly to the side of a printer. The other holes are blind 3mm and are meant to attach the boards with m3 screws. I've included a diagram and the f3d file so you can make any adjustments you need to.