Under the table Drawer System
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Need more minidrawers for under your workbench? Look no further ;-)
- Rating
- 0 / 5
- Likes
- 28
- Downloads
- 126
- Makes
- 1
- Views
- 1,110
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
Drawer outer size is 60x40x100mm.
For 2 drawer build, you need following parts:
1x Drawer
1x Left rail
1x Middle rail
1x Right rail
4x Topconnector
2x Leftrightstop
1x Middlestop
2x Knobs, use mine or your own. Knob hole on drawer is 4mm
For every extra drawer you wish to add, you'll need following:
1x Middle rail
1x Middlestop
2x Topconnector
1x Knob
Printing tips:
Use brim for everything except the drawers.
Check my Prusa Slicer project-file before starting. Removing supports from rails could be challenging. See that support isn't connected to the rail side and then removing it with small flat blade screwdriver is easy.
Installation:
I used T10 3x15 screws to all except middle stoppers.
T10 3x25 worked for them.
Assemble drawers, rails and topconnectors together.
Glue topconnectors to rails and let it dry. Overnight is the best, if you don't have a really fast superglue.
As you know, plastic on plastic could generate a lot of friction, so I used little bit silicon spray on rails and it worked fine. Drawers could need little maintenance on the road.
Remove drawers and start screws from left to right, one rail at the time, so you don't mess with tolerances and drawers will be too tight.
Drawer stoppers getting into your nerves? Me too…
When to install them and do you need them at all?
If you use drawers by completely removing them when opening, don't use any stoppers.
Middlestoppers could also be enough for you, but you need long T10 torx driver to install them.
Superglue left and right stoppers, if you need them.