Mr Stackbody the Snowman

A remix of my Mr Snow model, body/head is now three separate parts which stack on top of each other. This is mainly to allow ease of printing, fill the bed with snowman bodies, but also has the added advantage of allowing bigger versions to be printed more easily! There is a slight saving on material on the original 200% sized version of Mr Snow, including head, (34g using the figures from PrusaSlicer on 0.3mm layer height and 5% rectilinear infill), this is due to the new version having more perimeters), however the original version is slightly taller (see photo).

I have included slightly modified versions of all the accessory parts here, tailored for this version.

https://youtube.com/shorts/mCDGY_92OrY?feature=share

I have not tested making smaller versions of this model but would assume tolerances would tighten up too far at 50% so you might want to print slightly smaller for buttons, arms, nose and sunglasses. You will probably also want to separate the head part of the body model and print to one side as it may merge into the middle section

I have not tested printing larger but there should be no issue other than the dowel being a sloppy fit (maybe print that a bit bigger) and I positively encourage doing so, go big or go home!

Note that you will need to print 2 x the button file, 1 x all other files. Parts will need to be glued in place

Mrs Snow version is not currently included, Mrs versions of head, hat, arms and mittens may follow later if there is a demand