baofeng UV-5R dust cover

Baofeng uv-5r dust cover for mic/headphone plug

Flexible Bridge

Avoid printing it alongside the bend:

Should be angled ether perpendicular or 45° angled to bend:

There are 2 options:

1- Set support top z distance to 0 and it will ignore it as bridge

2- At PrusaSlicer 2.9.6 atm you can't change the bridging angle more than 45deg from origin, my suggestion to set it to 135 so it will go across the next layer at cross angle

Print Settings>Infill>Advanced>Bridging angle: 135°

SUPPORTS:

i used PLA as a support, since (afaik) pla and tpu don't stick well to each-other.

used PrusaSlicer with multiple extruders config.

pla as support config:  (pla is extruder 2)

To enable multiple extruders on single extruder printer in PrusaSlicer :

Printers>General>Capabilities:

  - increase extruder above  1

  - enable “Single extruder MM”

Printers>Custom G-code:

  - Tool change G-code = M600

z offset of 0.2 and 0 both worked good and were easy to separate

Filement: TPU (creozone)

Layer hight: 0.2

Printer: Prusa mini

Nozzle: 0.4