Y belt tensioner with standard M3 screw axle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Y belt tensioner for Mk3(S/S+). Remix of boogie's model, replacing the cylindrical pin with a standard M3 screw.
- Rating
- 4.929 / 5
- Likes
- 56
- Downloads
- 234
- Makes
- 17
- Views
- 1,158
- Reviews
- 14
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Replacement for the Prusa Mk3(S/S+) y-belt idler, to allow easier adjustment of the belt tension.
Boogie improved on his original design of a y-belt tensioner by requiring only 2 screws for tightening but for some reason replaced the M3 screw that is used by the Prusa stock idler with a cylindrical pin. Which of course wasn't in my toolbox, so after some quality time with Fusion 360 I had remixed boogie's design to use a standard M3x20 screw instead, similar to the M3x18 screw used in the original idler.
Parts required
- 2x M3x10 screw (from original idler)
- 3x M3 hex nut
- 2x M3 nyloc hex nut
- 3x M3x20 screws (boogie suggests M3x18 screws as tighteners but I found the M3x20 to give more range)
Print instructions
PETG. 3 perimeters, 15-20% gyroid infill, 0.2mm layer height. No supports.
Assembly
This is assuming you're replacing the original idler. For “orange” and “black” please see photo.
- Insert 1 hex nut in orange part. In case you can't press the nuts in: Take M3 screw, thread it from the opposite side of the printed part, as you tighten the screw, it will pull the nut in.
- Insert 2 hex nuts into the back side (with the “legs”) and 2 nyloc nuts into the front side of the black part.
- Unscrew the four screws that hold the LCD display in place and put it aside. Keep screws in place for late re-assembly.
- Unscrew the 2 M3x10 screws that hold the idler and set aside for reuse.
- Unscrew the M3x18 screw that secures the bearing in the idler. Remove bearing. Screw and nyloc nut are no longer needed.
- Hold the orange part with the little hole downward and the hex nut facing left.
- Push the belt back over the bearing (without twisting it) and insert the bearing into the orange part.
- Secure it with an M3x20 screw. Don't tighten too much, the idler needs to be able to spin freely.
- Insert the orange part into the black part (with the little hole facing down and the legs away from you). Insert 2 M3x20 screws, tighten them into the nyloc nuts, then unwind until they just stay in place.
- Attach the black part to the frame with the 2 original M3x10 nuts.
- Reattach the LCD display.
- Use the Prusa's “tension meter” to adjust proper tension, by tightening the 2 M3x20 screws that go through the tensioner equally.
If you like what I'm doing…
… consider buying me a coffee or joining my Club.